1. Validate disk status with this command : get system status

2. Most of em show a status : disk need formating

3. To format the disk : execute formatdisklog (il demande une confirmation et un reboot)

4. Once the device has rebooted :

– config log disk setting

– set status enable

5. In the log configuration section in the GUI, make sure that log writing is change to : log to disk

Tagged with:  

– Run the following command to enable debug :

  • diag debug enable

– Run the following command to display IPSEC message:

  • diag debug app ike -1

– To stop debug message display :

  • Diag debug disable
  • Diag debug app ike 0
Tagged with: